| TILE GLOW® #2
TILE GLOW® #2 is a natural, non wax, abrasive compound
for the thorough cleaning and honing of Ceramic, Porcelain and Quarry
Tiles.
TILE GLOW® #2 gives a long lasting shine,
protects and provides a slip resistant finish to ceramic tiles. It does
not yellow. The Tile Glow® Maintenance Program eliminates the
need for constant waxing and stripping of these tiles.
To apply TILE GLOW® #2, you need:
- TILE GLOW® #2
- Floor buffer (175 to 350 RPM). Water tank and splash
guard optional.
- One natural hair pad, one white buffing pad.
Note: Heavier buffer will give you a quicker and better polish.
We recommend the 13", 1.5 HP STONEWORKS buffer. Optimum weight of 135
lbs.
- Wet vacuum clean, mop, bucket, wringer, floor squeegee.
Directions
Note: The tile and baseboards should be stripped of all waxes or sealer
and neutralized.
- Cover baseboard, carpet, etc., with protective
plastic and/or tape.
- If the grout is very dirty, scrub the grout and
tile with our MINERAL DEPOSIT REMOVER (MDR) and a scrubbing brush. Wet
vacuum and rinse.
- If the floor is very dirty or old, thoroughly clean
and hone the tile with Tile Glow® #1. See Tile Glow® #1
instruction sheet.
- Wet a 25 Sq. Ft. area of the tile. Put a handful
of TILE GLOW® #2 on the wet area (5 oz./25 Sq. Ft.)
- Buff the TILE GLOW® #2 slurry with a
natural hair pad for about 20 minutes per 25 Sq. Ft.
- Check the level of gloss with the squeegee. When
the desired level of gloss is achieved, squeegee the TILE GLOW® #2
slurry to the adjacent area and repeat process. Add TILE GLOW® #2
and water as needed.
- Vacuum-dry the TILE GLOW® #2 mixture.
Wet again polished area and buff again with the same pad without adding
more TILE GLOW® #2 to remove residue.
- Vacuum-dry thoroughly, damp mop and let dry.
- Buff polished area with a dry white pad.
- If needed, seal the grout with our ARMOR-DILLO
water/stain repellent penetrating sealer
Note: TILE GLOW® #2 is available in white,
gray or black to suit grout colors.
Technical Specifications
Active Ingredient: Aluminum Oxide
Store in a Dry Place.
For further technical specifications see Material Safety Data Sheet.
PRECAUTION: The use of gloves and protective clothing
is recommended when using TILE GLOW® #2.
WARNING: Avoid contact with skin, eyes, clothes.
In case of contact, flush thoroughly with water and call Physician. Do
not swallow. Keep out of children's reach.
International Stoneworks, Inc., will not be liable
for any damage ensuing to property or injury to operator or any other
person due to the misuse or misapplication of TILE GLOW® #2 or any
other chemical sold by them.
Product Page
Download
MSDS in .doc Format
|
