Always pre-test in an inconspicuous area to insure product performance and satisfaction

1. Make sure all surfaces to be sealed are thoroughly clean, chemical residue free and completely dry before application of sealer.
2. Make sure all grout joints are thoroughly clean, chemical residue free, completely dry and properly cured before application of sealer.
3. Recommended application rates for most natural stone, tile and grout:
   • Very High Porosity: 50 - 200 sq. ft. per gallon / per coat
   • High Porosity: 200 - 400 sq. ft. per gallon / per coat
   • Medium Porosity: 400 - 800 sq. ft. per gallon / per coat
   • Low Porosity: 800 - 1600 sq. ft. per gallon / per coat

DIRECTIONS:

• Do not spray SEAL & GO® "S" with high pressure sprayers.
• Do not atomize SEAL & GO® "S" into the air.
• Do not breathe the spray mist of SEAL & GO® "S".
• When using spray equipment, do not overspray on glass, freshly painted surfaces, plants, furniture, etc. Wet overspray may be wiped up immediately with clean absorbent towels.
• Do not walk on wet sealer because the surface will be very slippery when wet.

SEAL & GO® sealers are not an absolute impenetrable barrier to all spills, soils or stains. However, natural stone, tile or grout properly sealed with SEAL N GO® sealers will repel stains more effectively and clean more easily when proper cleaning solutions and methods are used. SEAL & GO® sealers do not prevent general soiling nor do they eliminate the need for routine cleaning and proper care of the sealed surface.

1. Dust mop or sweep floors frequently to minimize dry soil abrasion. The most destructive material to natural stone is sand, dirt and grit which will scratch and dull the surface. These areas become places where dirt and stains will accumulate.
2. Walk off mats are recommended to eliminate dry soil from entering the building.
3. Vacuum walk off mats regularly.
4. Blot up spills immediately with clean absorbent towels.
5. Wet mop as needed with a pH-balanced cleaner such as LAVENET.
6. Always maintain stone with clean mops, towels, sponges or rags.
7. Do not use acid based cleaners (below 7pH), high alkaline (above 9pH) cleaners or strong degreasers.
8. Rinse well, if needed, with clear water to avoid leaving chemical residue.
9. Cleaning chemical residues can leave a sticky film, attract dirt and degrade the sealer.
10. Re-apply SEAL & GO® sealers every 1 to 2 years in medium to heavy use areas.
11. Re-apply SEAL & GO® sealers every 2 to 3 years in light use areas
12. For re-application procedures, refer to the SEAL & GO® sealers Application Instructions.

Natural stone needs to be cared for properly. Natural stone is a material made of minerals that may react negatively to chemicals that are not specifically intended for stone care use. If it is neglected and abused, the natural beauty of the stone will not be preserved. It is vital that your natural stone be maintained in accordance with the above recommended procedures. Improper cleaning chemicals or procedures will void the warranty.

International Stoneworks Inc. warrants that this product conforms with the SEAL & GO® written specifications and is free from defects. International Stoneworks Inc. disclaims all other warranties, express or implied, including the warranties of merchantability, fitness for a particular application, or any other matter. The buyer's sole remedy for non compliance with this warranty shall be for the replacement of the product or the refund of the buyer's purchase price. In no case will International Stoneworks Inc. be liable for direct, indirect, consequential, economic or other damage. International Stoneworks Inc. will not be responsible for the damage to property or injury to persons due to the improper use or misapplication of SEAL & GO® or any other chemicals sold by the company.

Product Page