|
EMERALD SPARKLE®
is a no-wax compound for the polishing of worn Serpentine & green marble
surfaces. Emerald Sparkle® contains high quality abrasives. Emerald
Sparkle® does not replace diamond grinding of marble surfaces; it is used
as a part of a non-wax maintenance polishing system for green marble surfaces.
To apply the Emerald Sparkle®
system, you need:
- Emerald Sparkle®, Buff &
Go® Plus
- Floor Buffer (IS-17, 200
RPM weighted).
- Natural hair pads and steelwool
pads grade 00
DIRECTIONS: OPTION I: WET
POLISHING
- Cover baseboard, carpet,
etc., with protective plastic and/or tape.
- Strip the floor (if needed)
with Zoom or Strip
& Go™
- Wet marble floor (25 Sq.
Ft.). Pour a small amount of the Emerald Sparkle® compound on the floor
(about 3 oz. for 10 Sq. ft.).
- The Emerald Sparkle® mixture
should make a slurry of "yogurt" consistency.
- Buff the slurry with a natural
hair pad for about 15 minutes per 25 Sq. Ft.
- Check level of gloss with
a squeegee. When the desired level of gloss is achieved, repeat the
procedure in the adjacent area.
- Vacuum dry the Emerald Sparkle®
slurry. Wet again polished area and buff again with the same pad to
loosen up excess residue.
- Vacuum dry, damp mop, let
dry.
- When dry, polish with a
dry white pad.
- When completely dry, mix
a small amount of Emerald Sparkle® (2 oz.) with a few drops of Buff
& Go Plus® and buff with the grade 00 steel wool pad until the
marble is polished and dry.
- Repeat the same procedure
on the adjacent areas.
DIRECTIONS: OPTION II: DRY
POLISHING
Place two ounces of Emerald
Sparkle® on the floor and buff immediately with the natural hair or felt
"Zebra" pad until dry and polished. To reduce pad friction, if any, spray
a few drops of water during the polishing process.
Technical Specifications:
Active Ingredient: Aluminum
oxide
For further technical specifications see Material Data Sheet.
Usage:
Usual Maintenance: 1 Lb./100
to 150 Sq. Ft.
PRECAUTION: The use of gloves and protective clothing is recommended when
using Emerald Sparkle®
WARNING: Avoid contact with skin, eyes, and clothes. In case of contact,
flush thoroughly with water and call physician. Do not swallow. Keep out
of children's reach.
International Stoneworks,
Inc., will not be liable for any damage ensuing to property or injury
to operator or any other person due to misuse or misapplication of Emerald
Sparkle® or any other chemicals sold by them.
View
MSDS
|
